OAR 340-150-0450
Automatic Tank Gauging Release Detection Method


(1)

An owner and permittee using equipment for automatic tank gauging (ATG) that tests for the loss of a regulated substance and conducts inventory control as a release detection method must use equipment that meets the requirements of this rule. The ATG system must:

(a)

Be able to detect a 0.2 gallon per hour leak rate with a probability of detection of at least 95 percent and a probability of false alarm of no more than 5 percent for all portions of the UST that routinely contain a regulated substance; and

(b)

The ATG system must be an approved leak detection method or equipment as listed by a national organization (e.g., the National Work Group on Leak Detection).

(2)

For USTs, an owner and permittee must monitor and test for releases at least once every 30 days and record the results for each month.

(3)

For underground piping, an owner and permittee must monitor and test for releases if the ATG system is designed to detect a release from any portion of the underground piping that routinely contains a regulated substance and record the results for each month as follows:

(a)

Daily for pressurized piping.

(b)

Once every 30 days for suction piping.

(4)

An owner and permittee must:

(a)

Report to DEQ any leak test results indicating the possibility of a release (i.e., test failure) within 24 hours as a suspected release (OAR 340-150-0500 (Reporting Suspected Releases)) and immediately begin investigation under OAR 340-150-0510 (Suspected Release Investigation and Confirmation Steps); and

(b)

Immediately investigate all larger-than-normal or reoccurring variations in results, including widely fluctuating water levels in the tank and report such variations as a suspected release if the variation cannot be accounted for, without waiting to obtain a second month of data.

(5)

An owner and permittee must retain at a minimum the most current 12 consecutive months of release detection records.

(6)

ATG systems installed before December 22, 1990, are exempt from the leak rate quantities, probability limits and third party evaluation requirements of this rule, except:

(a)

The ATG system must be able to detect a 0.2 gallon per hour leak rate from any portion of the UST that routinely contains a regulated substance; and
(b) The ATG equipment must meet the inventory control (or other test of equivalent performance) requirements of 340-150-0430 (Inventory Control Method of Release Detection) and the test must be performed with the system operating in one of the following modes:
(A) In-tank static testing conducted at least once every 30 days; or
(B) Continuous in-tank leak detection operating on an uninterrupted basis or operating within a process that allows the system to gather incremental measurements to determine the leak status of the tank at least once every 30 days.

(c)

An owner and permittee may only use the ATG system to obtain daily regulated substance volumes for the inventory control release detection method (OAR 340-150-0430 (Inventory Control Method of Release Detection)) if the ATG does not meet the requirements of section (1) of this rule.

Source: Rule 340-150-0450 — Automatic Tank Gauging Release Detection Method, https://secure.­sos.­state.­or.­us/oard/view.­action?ruleNumber=340-150-0450.

340‑150‑0001
Purpose and Scope
340‑150‑0006
Applicability and General Requirements
340‑150‑0008
Exemptions and Deferrals
340‑150‑0010
Definitions
340‑150‑0020
UST General Permit Registration Certificate Required
340‑150‑0021
Termination of Temporary Permits
340‑150‑0052
Modification of Registration Certificates For Changes in Ownership and Permittee
340‑150‑0080
Denial, Suspension or Revocation of General Permit Registration Certificates
340‑150‑0102
Termination of General Permit Registration Certificates for Installation, Operation and Temporary Closure
340‑150‑0110
UST General Permit Registration, Annual Compliance and Other Fees
340‑150‑0135
General Requirements for Owners and Permittees
340‑150‑0137
UST Systems with Field-Constructed Tanks and Airport Hydrant Fuel Distribution Systems
340‑150‑0140
Requirements for Sellers of USTs
340‑150‑0150
Depositing Regulated Substances in USTs
340‑150‑0152
Requirements for Distributors of Regulated Substances for Deposit into USTs
340‑150‑0156
Performance of UST Services by Owners or Permittees
340‑150‑0160
General Permit Requirements for Installing an UST System
340‑150‑0163
General Permit Requirements for Operating an UST System
340‑150‑0167
General Permit Requirements for Temporary Closure of an UST System
340‑150‑0168
General Permit Requirements for Decommissioning an UST System by Permanent Closure or Change-in-Service
340‑150‑0180
Site Assessment Requirements
340‑150‑0200
Training Requirements for UST System Operators and Emergency Response Information
340‑150‑0210
Training Requirements for UST Operators
340‑150‑0250
Expedited Enforcement Process
340‑150‑0302
Installation of Used USTs
340‑150‑0310
Spill and Overfill Prevention Equipment and Testing Requirements
340‑150‑0315
Periodic operation and maintenance walkthrough inspections
340‑150‑0320
Corrosion Protection Performance Standards for USTs and Piping
340‑150‑0325
Operation and Maintenance of Corrosion Protection
340‑150‑0350
UST System Repairs
340‑150‑0352
UST System Modifications and Additions
340‑150‑0354
UST System Replacements
340‑150‑0360
Requirements for Internally Lined USTs
340‑150‑0400
General Release Detection Requirements for Petroleum UST Systems
340‑150‑0410
Release Detection Requirements and Methods for Underground Piping
340‑150‑0420
Release Detection Requirements for Hazardous Substance UST Systems
340‑150‑0430
Inventory Control Method of Release Detection
340‑150‑0435
Statistical Inventory Reconciliation Method of Release Detection
340‑150‑0440
Manual Tank Gauging Release Detection Method
340‑150‑0445
Tank Tightness Testing for Release Detection and Investigation
340‑150‑0450
Automatic Tank Gauging Release Detection Method
340‑150‑0465
Interstitial Monitoring Release Detection Method
340‑150‑0470
Other Methods of Release Detection
340‑150‑0500
Reporting Suspected Releases
340‑150‑0510
Suspected Release Investigation and Confirmation Steps
340‑150‑0520
Investigation Due to Off Site Impacts
340‑150‑0540
Applicability to Previously Closed UST Systems
340‑150‑0550
Definitions for OAR 340-150-0555 and 340-150-0560
340‑150‑0555
Compliance Dates for USTs and Piping
340‑150‑0560
Upgrading Requirements for Existing UST Systems
340‑150‑0600
Delegation of Program Administration
340‑150‑0620
Approval of More Stringent Performance Standards
Last Updated

Jun. 8, 2021

Rule 340-150-0450’s source at or​.us